For custom van conversions
Plan your van conversion in 3D.
Place a part in a 3D model of your van, and Raeda counts it everywhere it matters: power, water, weight, budget and build order.
01 · Power
Power that adds up
Place a 12 V compressor fridge and its watts join the load, then its daily watt-hours once you say how long it runs. Raeda adds up every draw in the build, then sizes the battery bank to carry it and the solar to refill it.
02 · Water
Fresh in, grey out
Add a fresh-water tank and its gallons are counted beside your grey tank's. Raeda tells you when the grey side is small for the fresh water you carry.
03 · Weight and payload
Know what you can still carry
Set down the bed platform and its weight comes off your payload. Raeda tracks what is left of the van's rated payload and how the load splits between the front and rear axles, with a note when an axle goes over its rating.
04 · Budget
Price it once
Price the galley cabinet and it is in the budget, with nothing to enter twice. What you have spent and what you still have to buy are counted apart, against a target for each category and one for the whole build.
05 · Build order
Wire it before you close the wall
Place the battery bank and it joins your Electrical System task. Walls & Ceiling waits on electrical, plumbing, insulation and framing, and Raeda won't let you mark it done until they are.
06 · Paste a link
Skip the spec sheet
Paste the product page for a diesel heater, and Raeda reads its size, weight, power draw and price for you to check before it goes in. Your van starts the same way, from a link to its spec page.
Start your build- Daily load
- 0 Wh
- Battery needed
- 0 Ah
- Fresh water
- 0 gal
- Payload
- 4,000 lbs
- To buy
- $0